Use the jig saw to cut along the second line to remove a portion of the PVC circumference.This diameter of pipe can accommodate bigger birds, as they will need a bigger opening in order to get at feed lying in the bottom of the feeder. For 4" diameter PVC pipes, make the opening a little larger than ¼ of the diameter.This diameter of pipe will accommodate chicks and younger birds, with enough room to allow them to reach feed lying in the bottom of the feeder. For 2" or 3" diameter PVC pipes, place your second cut about ¼ of the circumference from the first cut.The distance of this cut from the first cut will vary based on the diameter of your PVC pipe: From the cut that has just been made, at each end of the pipe, measure and mark off another cut with the chalk line.Using a jig saw, cut along the length of the chalk line.Using this text as a guide, lay a straight chalk line along the length of the 5' section of PVC pipe. There is information printed lengthwise along each PVC pipe.Your feeders will be easier to prepare in 5' sections, and they can fit in smaller poultry huts as well. Cut the PVC pipe in half, using the circular saw. Find the middle point of the 10' length of PVC pipe.Eyelet screws to tie to ceiling (insert into the top part of the plug).Screws to hold plugs in place (about 1 inch long).Wood for plugging ends of pipe (about 2 inches thick).2" or 3" diameter for chicks and young birds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |